2 · Set up the arm
Goal: the follower copies the leader smoothly and both cameras show the right view.
Install
git clone https://github.com/fport/so101-flywheel && cd so101-flywheel/python
uv sync --extra robot # LeRobot 0.6.1 with the Feetech servo driver
hf auth login # token with write access
Tell the scripts about your rig
uv run lerobot-find-port # unplug one arm when asked; note both ports
uv run lerobot-find-cameras opencv # saves one frame per camera, note the two indices
Put the four values in scripts/env.sh. Every script reads them from there and prints the
full lerobot-* command before running it, so you always see what runs.
Calibrate (once)
scripts/calibrate.sh follower
scripts/calibrate.sh leader
Move the arm to the middle of every joint, press Enter, then sweep each joint end to end. Calibration maps raw servo
ticks to the same angle on both arms; it is saved in hardware/calibration/. Recalibrating after you have recorded
changes what the numbers in your dataset mean: do it before, not in between.
Teleoperate
scripts/teleop.sh # arms only
scripts/teleop.sh --cams # plus both cameras in Rerun
Hold the leader near the follower's pose before you start: the follower jumps to the leader on connect.
Check
- Top camera: tray, both bins and the whole reach of the arm are in frame, nothing else moves in it.
- Wrist camera: both jaw tips and the space between them are visible.
- Do the task once while looking only at the two camera windows, not at the desk. If you cannot do it from the images, the policy cannot either. Move the cameras until you can.
- Practise until one pick-and-drop takes about 10 seconds without fumbling.
Rerun and macOS. Showing live cameras costs CPU and has stalled the control loop here. Use --cams to aim the
cameras, then record without a viewer (the recording script does this).